Uploaded June 2021 | Updated September 2026, 2 hours ago
Against popular belief, single engine scrapers can indeed self load...they're just super slow.
However, it's obviously not as efficient as being push loaded by a dozer since they're only front wheel drive---but if needed, a fleet of singles can make due for bit without a push cat if the conditions are right.
There are various reasons why a push cat may be down briefly (Getting serviced or a small repair) In one of those cases where it's only for a short time, you can at least keep some production going.
Dirt must have a certain compaction and consistency (not too hard or too soft) and without rocks.
They will also need a very long cut as they will only be able to cut an inch or two over a very long stretch. Oh and you MUST have very experienced operators to avoid wheel spin.
Against popular belief, single engine scrapers can indeed self load...they're just super slow.
However, it's obviously not as efficient as being push loaded by a dozer since they're only front wheel drive---but if needed, a fleet of singles can make due for bit without a push cat if the conditions are right.
There are various reasons why a push cat may be down briefly (Getting serviced or a small repair) In one of those cases where it's only for a short time, you can at least keep some production going.
Dirt must have a certain compaction and consistency (not too hard or too soft) and without rocks.
They will also need a very long cut as they will only be able to cut an inch or two over a very long stretch. Oh and you MUST have very experienced operators to avoid wheel spin.
