Uploaded February 2013 | Updated November 2026, 3 hours ago
Used one of the templates in iMovie to try to learn it. The footage is from an demo experiment in a square tank of water, 15 cm deep, 60 cm on a side. The tank is impulsively spun-up to ~10 rpm. The camera is in the rotating frame. This allows you to see the fluid mechanics pretty well. The fluid takes about 10 minutes to spin-up to the rotation rate as the tank. The fluid near the outside is spin up first (non-intuitively, spin-up away from the corners of the tank occurs predominantly by centrifugation of fluid through the bottom Ekman boundary layer, not sidewall friction); the fluid near the center lags behind. This cylindrical shear (du_phi/ds) leads to the spiral galaxy patterns in the dye.
Visualization. The flow in the bulk fluid can be seen with the food coloring. The Ekman boundary layer can be seen thanks to the potassium permanganate crystals at the bottom of the tank. Lastly, note that there are some nice corner vortices as well.
Used one of the templates in iMovie to try to learn it. The footage is from an demo experiment in a square tank of water, 15 cm deep, 60 cm on a side. The tank is impulsively spun-up to ~10 rpm. The camera is in the rotating frame. This allows you to see the fluid mechanics pretty well. The fluid takes about 10 minutes to spin-up to the rotation rate as the tank. The fluid near the outside is spin up first (non-intuitively, spin-up away from the corners of the tank occurs predominantly by centrifugation of fluid through the bottom Ekman boundary layer, not sidewall friction); the fluid near the center lags behind. This cylindrical shear (du_phi/ds) leads to the spiral galaxy patterns in the dye.
Visualization. The flow in the bulk fluid can be seen with the food coloring. The Ekman boundary layer can be seen thanks to the potassium permanganate crystals at the bottom of the tank. Lastly, note that there are some nice corner vortices as well.










