Project Pootle [ Ep #3 - Build ] @MrE.
Project Pootle [ Ep #3 - Build ]  @MrE.
Uploaded September 2018 | Updated September 2026, 5 hours ago
Nice simple clean build.

Frame: bit.ly/2DevqzK
Motors: bit.ly/2NX3jZQ bit.ly/2pqFony
Esc's: bit.ly/2fyiYgD
Flight Controller: bit.ly/2bKghXo
Camera & VTX: bit.ly/2xBGf8W
Receiver: bit.ly/2plJHki

Thank you for watching, I'm always happy to converse, answer questions & happy to take content suggestions for future videos if possible so please leave a comment, I always aspire to answer each and every one!
If this video helped you in any way, please rate the content - I appriciate it very much.

My Gear:
Runcam 3: bit.ly/2sOuQOr
FrSky Taranis X-Lite : bit.ly/2DA8xlI
Aomway Commanders: bit.ly/2xClXuP
Runcam 3: bit.ly/2sOuQOr

Data burst containing the usual information can be found on the outro.
Project Pootle [ Ep #3 - Build ]Roller coaster with the Spec [ Week 21 TT - Up Down Up By SFPV ]Tinyhawk S - Rapid Review  [ Courtesy Banggood ]IGOW 5 TG #2Drox Summer Series - 8 A1Rotor Riot CL1 Frame [ Quick look ]RaceGow 5 [Track 3]SGDC FunFly Q3HWTC  Tiny Whoop Race @ Popham Model RC & Air Show [ P1! ]A Texas run [ Dec 22 ]IGOW 5 Challenge 2 [ BetaFPV Triple Gate Stack ] - RedeuxMrE | IGOW3 | Week 19 - Drone Cadets Rewinds
MrE |

Project Pootle [ Ep #3 - Build ]

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER