Keysight Design Software | Prepare your Power Converter Design for EM Simulation using PEPro @KeysightEEsofEDA | Uploaded August 2023 | Updated October 2024, 3 hours ago.
This video presents a comprehensive walkthrough demonstrating how to prepare your power electronics design for electromagnetic simulation using Keysight’s PEPro. When transitioning your design into PEPro, the primary hurdle lies in accurately configuring it to match the software's electromagnetic (EM) solver requirements. This phase often perplexes power electronics designers since their expertise usually centers on schematic-level simulation. By the conclusion of the video, you will have gained a solid comprehension of importing your design into PEPro and mastering the crucial steps essential for a productive EM simulation preparation.
Apply for a free trial of PathWave Advanced Design System (ADS) at:
keysight.com/find/ads-evaluation
To learn more:
keysight.com/find/ads
keysight.com/products/W3631B
Watch other videos in this series:
- Getting Started with ADS
- Using the Power Electronics Model Builder
- Using the Optimizer in ADS
- Setting up a Post-Layout EM Simulation in PEPro
This video presents a comprehensive walkthrough demonstrating how to prepare your power electronics design for electromagnetic simulation using Keysight’s PEPro. When transitioning your design into PEPro, the primary hurdle lies in accurately configuring it to match the software's electromagnetic (EM) solver requirements. This phase often perplexes power electronics designers since their expertise usually centers on schematic-level simulation. By the conclusion of the video, you will have gained a solid comprehension of importing your design into PEPro and mastering the crucial steps essential for a productive EM simulation preparation.
Apply for a free trial of PathWave Advanced Design System (ADS) at:
keysight.com/find/ads-evaluation
To learn more:
keysight.com/find/ads
keysight.com/products/W3631B
Watch other videos in this series:
- Getting Started with ADS
- Using the Power Electronics Model Builder
- Using the Optimizer in ADS
- Setting up a Post-Layout EM Simulation in PEPro