PERFECT!! FLAT GRIND IN 6 MINUTES | Multi Guide @BigIronTV

Uploaded April 2018 | Updated September 2026, 31 minutes ago

Using a Multi Guide Mastersmith bevel guide by Belnap Custom Knives. Belt is an 80 grit cubitron that has already ground 30 blanks so far and still going well.
The sander is powered by a special design drive system that uses a 24,000 RPM water cooled spindle motor and cost a grand total of only $600.00 for the entire drive assembly, motor, and VFD.

PERFECT!! FLAT GRIND IN 6 MINUTES | Multi Guide

Bevel Guide Mount for 1.5 single arm machines such as KMG

I Know the Video is crap but I could not wait to show it

2 x 72 Belt Sander Build | Spindle Motor Bench Test

2 x 72 Aluminum Frame Build | 2 x 72 sander | High Performance Frame | Part 1

Multi Guide Built from Steel Using DIY Plans from Belnap Custom Knives

2 x 72 Sander Vibration, Tracking, Speed, Reverse Demonstration

Aluminum Frame 2 X 72 Knife Grinder - Part 1

2 X 72 Sander With 10 Wheel and Table in Horizontal Position