Patchin with PrssPnt and Ch.Svr | Make Noise @MAKEN0ISEMUSIC
Patchin with PrssPnt and Ch.Svr | Make Noise  @MAKEN0ISEMUSIC
Uploaded May 2024 | Updated November 2026, 1 hour ago
0:00 Intro
0:11 Manual Sequence Sample & Hold
1:47 Multi-Source Filter Modulation
3:02 Clock Subtraction
4:47 Digital Sandwich Dissection
6:38 Zone of Post-Binary Sequencing
9:39 Manual Sequencing


The PrssPnt music synthesizer module is a controller in which several signals are generated by touching the printed copper wire at the bottom of the instrument.  Touching PrssPnt, you become part of the circuit, generating a total of four simultaneous signals (two CV, two Gate). 

The basic function of PrssPnt will be familiar to anyone who has used Pressure Points or 0-CTRL. It could be seen as a single “souped-up” channel of one of these devices. Since it is a single channel, the tuned voltage outputs are not relevant, and instead are replaced with more playable sensitivity controls and alternate pressure and gate outputs.


• Momentary Gate output remains high as long as it is being pressed
• Toggled Gate output goes high and low with each successive press of the plate: press it to make it go high, press it again to make it go low
• Pressure output generates a positive control signal proportional to the amount of Pressure applied, further tailored by the Sensitivity Panel Control
• Smooth Touch Function recreates the useful patch of sending a Pressure Output through a carefully tuned slew limiter for extended function generation 
• Turning up the Slew amount will allow for larger than life functions with very long decay to be generated by hand.
• All four outputs available simultaneously


Specs:
4hp
14mA @+12V
0mA @-12V 
30mm depth (incl. power cable)

makenoisemusic.com/modules/prsspnt

——


The Channel Saver music synthesizer module is a small utility module, offering several channels of signal-processing that will be useful in just about any modular system. As a condensation/extension of the sum/offset/attenuversion aspects of MATHS, it continues the great tradition of sculpting the control signals we use to sculpt our sound signals. 

• Scale, amplify, attenuate, or invert an incoming signal using Channels 1 or 2
• Generate DC offsets when Channel 1 or 2 is unpatched
• Crossfade between two signals, or attenuate one signal, using Channel 3
• SUM and INVerted Sum Bus for addition, subtraction, mirroring, inversion etc. 
• Individual Channel Outputs for Channels 1 and 2 allow independent use of all three channels
• Anywhere you need more subtle modulation, Ch. Svr is there for you… now all your eurorack slivers may have subtle and intentional modulation they deserve! 


Specs:
6hp
20mA @+12V
10mA @-12V
30mm depth (incl. power cable)

makenoisemusic.com/modules/ch-svr
Patchin with PrssPnt and Ch.Svr | Make NoiseThe Story of the DPO with Tony Rolando | Make NoiseGatin the PoliMATHS | Make Noise3 SpectraNoise Patches with James Cigler | Make NoiseA Patch to Get Started with the New Universal Synthesizer SystemHarmonic sweeps with the New Universal Synthesizer System!Plexiphon adds texture to any signal!Creating massive Unison sounds with MultiWAVE!BRUXA and the BEAST | Make NoiseSpectral Microsonics | Make Noise
MAKEN0ISE |

Patchin' with PrssPnt and Ch.Svr | Make Noise

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER