Uploaded March 2020 | Updated November 2026, 4 days ago
Single Supply vs Dual Supply OPAMP, Negative Rail and Positive Rail, EASY!
Voltage Follower
======================================
Check other videos: bit.ly/2N9OlPa
======================================
OPAMPs are very important components in Electronics, however they could be tricky even for experienced users. In this video, I prepared some experiments to show you how single supply and dual supply OPAMPs are different and why we should provide both positive rails and negative rails for the dual supply OPAMP in any case. The circuit configuration that I used is voltage follower.
In case of using a single supply OPAMP, if the input signal include a negative part, then we have to include the negative rail as well.
Just check your project requirements and read the datasheets carefully.
#opamp
#single_supply
#dual_supply
Single Supply vs Dual Supply OPAMP, Negative Rail and Positive Rail, EASY!
Voltage Follower
======================================
Check other videos: bit.ly/2N9OlPa
======================================
OPAMPs are very important components in Electronics, however they could be tricky even for experienced users. In this video, I prepared some experiments to show you how single supply and dual supply OPAMPs are different and why we should provide both positive rails and negative rails for the dual supply OPAMP in any case. The circuit configuration that I used is voltage follower.
In case of using a single supply OPAMP, if the input signal include a negative part, then we have to include the negative rail as well.
Just check your project requirements and read the datasheets carefully.
#opamp
#single_supply
#dual_supply






![Standalone Full Bridge DC Motor Driver
Standalone Full Bridge (H Bridge) DC Motor Driver using Tiny13 and IR2104
Altium Designer + License (Free): https://www.altium.com/yt/myvanitar
OctoPart: https://octopart.com
Article: https://www.pcbway.com/blog/technology/A_Standalone_Full_Bridge_DC_Motor_Driver_2c7c2086.html
Other Videos: http://bit.ly/2N9OlPa
The Full-Bridge (H-Bridge) is the most popular driver circuit to control brushed DC motors. The main advantage of a full bridge driver is the ability to change the rotation direction of the motor, without manually reversing the supply wires. I’ve already published the Half-bridge and H-bridge driver circuits before; however, I was receiving many requests and comments for a standalone H-Bridge driver to control the DC motors, without using any external board or a controller.
Therefore, I introduced a cheap, compact, and standalone H-Bridge DC motor driver that can be embedded in a variety of mechatronic devices. A cheap ATTiny13 microcontroller controls everything and I used the Arduino IDE to write the microcontroller code. All components, except for the connectors, are SMD.
The motor can be controlled in three modes: Forward, Stop, and Reverse. The user can adjust the rotation speed of the motor separately in the forward or reverse direction, using two panel-mounting potentiometers. The low ON-Resistance of the Mosfets allows you to use this circuit in high currents.
To design the schematic and PCB, I used Altium Designer 22. The fast component search engine (octopart) allowed me to quickly collect the components’ data and generate the BOM as well. To get high-quality fabricated boards, I sent the Gerber files to PCBWay. To test the driver board, I disassembled an electric toy car and used its powerful 775 DC motor (plus the gearbox).
It’s a cool experience, just build one and have fun!
Specifications
Input Voltage (Motor): 8-40VDC
Supply Voltage (Controller): 12VDC
PWM Frequency: 25KHz
Motor Control: Forward-Stop-Reverse
Motor Speed: [0 to 100%] Forward, [0 to 100%] Reverse Standalone Full Bridge DC Motor Driver](https://i.ytimg.com/vi/lbVwRdweDYA/mqdefault.jpg)



