onepulse bouncer test 2.wmv @woopyjump
onepulse bouncer test 2.wmv  @woopyjump
Uploaded March 2011 | Updated November 2026, 4 days ago
This setup is made to better understand the power of a pendulum.
To do this i use a pendulum made of magnet stack which are also the motor magnet.
Than a coil (air core and very thin) gives the push to the rotor to overcome the small distance to complete the 360 degree from the original free fall rotation.
So if i let the rotor free falling from 12 oclok, it will swing up to about 10 oclock, and than go back until stop.
But if i can chop the rotor at 10 oclock (at the end of the up swing ) and give him the slight push to pass the 12 oclok ,than it will goes on for a next rotation..
By doing this , for a very low power input i can get the complete rotation of the heavy pendulum.
This pendulum get very strong centrifugal force (especially near the bottom swing) before going up to 10 oclock by inertial force,
And the question is

HOW TO USE THE CENTRIFUGAL FORCE OF THE BOTTOM SIDE OF THE SWING

here some experiment
but we can do MUCH better

good luck at all

Laurent
onepulse bouncer test 2.wmvcaduceus coil on delamorto 1.wmvRosemary Ainslie ofset testing1.wmvultralight formation  woopy 2Inertial propulsion with a gyroscope part 1bifilar Tesla pancake  wireless coupling.wmvenergy from ambientinertial propulsion with gyroscope part 14freewheeling magnifier test 1.wmvonepulse shaking idea 1.wmvinertial propulsion with gyroscope extra 9.5 partPart 5  bACK emf versus flyback spike test
woopyjump |

onepulse bouncer test 2.wmv

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER