Uploaded September 2019 | Updated November 2026, 4 days ago
Remember to join the Discord Server! discord.gg/wZBXf4B
In this video I show the process I followed to install a RV Style air conditioning unit on my shipping container electrical room. I already had a full automation control panel so I just tied in the air conditioner to that and wrote a new program for the PLC to control it.
PLC & Programming info:
automationdirect.com/adc/overview/catalog/programmable_controllers/click_series_plcs_(stackable_micro_brick)?gclid=Cj0KCQjwwb3rBRDrARIsALR3XebM9oICFReWYlGFk9Ovyn5pZbHyM04AGzwfgrOuVGgc27n1_wbseQkaAnWNEALw_wcB#bodycontentppc
A few changes that were made to the system after this video was shot had to do with system protection.
First off I installed a module that allows the PLC to read battery voltage. This means if the battery voltage is below a set point the AC cannot run, this voltage is set right around the float voltage of the bank, I believe 55.85 volts default. Once this set point is reached, a timer adjustable via the HMI is started, default time of 30 seconds, so that the PLC ensures the battery voltage stays above said value for a decent amount of time prior to kicking on the AC. After the timer elapses then the code that handles the startup scheme and temp control is brought into effect. Additionally if the battery voltage drops below the set point, the plc will wait 30 seconds before shutting the AC off to account for a brief dip.
I also have a 5 minute delay so that once the unit shuts down, it cannot be powered back up for 5 minutes.
Remember to join the Discord Server! discord.gg/wZBXf4B
In this video I show the process I followed to install a RV Style air conditioning unit on my shipping container electrical room. I already had a full automation control panel so I just tied in the air conditioner to that and wrote a new program for the PLC to control it.
PLC & Programming info:
automationdirect.com/adc/overview/catalog/programmable_controllers/click_series_plcs_(stackable_micro_brick)?gclid=Cj0KCQjwwb3rBRDrARIsALR3XebM9oICFReWYlGFk9Ovyn5pZbHyM04AGzwfgrOuVGgc27n1_wbseQkaAnWNEALw_wcB#bodycontentppc
A few changes that were made to the system after this video was shot had to do with system protection.
First off I installed a module that allows the PLC to read battery voltage. This means if the battery voltage is below a set point the AC cannot run, this voltage is set right around the float voltage of the bank, I believe 55.85 volts default. Once this set point is reached, a timer adjustable via the HMI is started, default time of 30 seconds, so that the PLC ensures the battery voltage stays above said value for a decent amount of time prior to kicking on the AC. After the timer elapses then the code that handles the startup scheme and temp control is brought into effect. Additionally if the battery voltage drops below the set point, the plc will wait 30 seconds before shutting the AC off to account for a brief dip.
I also have a 5 minute delay so that once the unit shuts down, it cannot be powered back up for 5 minutes.










