How NOT to connect a Potentiometer (Whats inside and how did it blow) @HighTechLab
How NOT to connect a Potentiometer (Whats inside and how did it blow)  @HighTechLab
Uploaded May 2019 | Updated November 2026, 7 hours ago
Remember to join the Discord Server! discord.gg/wZBXf4B

This video was inspired by a mistake I had made when installing a 10k ohm potentiometer that was supposed to serve as a voltage divider before feeding into my 0-50v to 4-20ma voltage transducer. This division was made necessary due to the fact that the battery voltage on the 48 volt system can reach voltages up to 64 volts during an equalize cycle on Flooded Lead Acid batteries, which would be outside of the acceptable input range. Since there is already scaling happening inside of the PLC, all I need to do is adjust the scaling by the amount of the voltage transducer plus the amount of scaling caused by the voltage divider.

It took me quite a while to figure out the whole idea of using a pot as a voltage divider. I had always thought that voltage dividers needed to be made up of multiple resistors with carefully selected values - until a partner of mine whom is an electrical engineer had suggested to pick up a handfull of pots. I stopped by Fry's electronics in Fremont, CA and picked up the only wire wound pot they had. Unfortunately Frys carries less and less of these parts that hobbyists like myself need for projects like this...I was looking for a few different resistance values and only could find the one they had. I will be going to amazon for the purchase of my next one.

It was a pretty cool video and a fun experience taking this device apart. I knew it was wire wound, but in my mind to have a single wire that in a package no more than 3/4" x 3/4" equated to 10,000 ohms of resistance seemed insane to me. Based on what I learned and showed in this video is very much is possible and quite the engineering accomplishment. The strand of wire had an insane amount of tensile strength, in fact I struggled to try and pull it to the point where it would snap. It is very very very fine, much smaller than a human hair.

One of the questions that I still have is how exactly the wiper moves up and down across the different layers of windings. I was not able to figure this part out.
How NOT to connect a Potentiometer (Whats inside and how did it blow)Off Grid Power Room Rebuild PT 6Off Grid Power Room Update - Heat Shrinking Buss Barstesla coil primary circutWelding The Roof Of Our Shipping Container Lab (Ep. 3)Tekkro: Starting guide for DummiesHow to Make Living Off The Grid Easy With PLC AutomationTekkro: Working on UltrastoreUse ELECTRICITY, Clean Stainless Steel Tig Welds (The machine I built to do it)Environmental Chamber:Testing in Extreme Deep Cold or Extreme Heat!Installing a Sol-Ark 15k on my home in Las VegasHUGE Off Grid Pure Sine Wave Inverter 36 KW Peak
HighTechLab |

How NOT to connect a Potentiometer (What's inside and how did it blow)

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER