Uploaded October 2016 | Updated November 2026, 3 hours ago
One channel had a pegged-out LED display at all times. I discovered that one of the diodes on the LED board was not putting out the correct waveform. It did not seem to be an original either. This diode was removed. Swapping the diode from the good channel seemed to have cleared up the problem. A 1N4148 diode was tried as a replacement for the removed non-original diode. This did not work. Most likely an original 1SS53 diode must be used.
One channel had a pegged-out LED display at all times. I discovered that one of the diodes on the LED board was not putting out the correct waveform. It did not seem to be an original either. This diode was removed. Swapping the diode from the good channel seemed to have cleared up the problem. A 1N4148 diode was tried as a replacement for the removed non-original diode. This did not work. Most likely an original 1SS53 diode must be used.










