Uploaded April 2026 | Updated September 2026, 1 week ago

---

Ford Transit vans have a lot going for them, but not these foam blobs. These awkward factory foam pieces are one of the most frustrating finishing challenges in a Transit build. You can ignore them, work around them, or do something else with them. In this video, I'm showing you exactly how I tackled mine to get a clean, seamless look that matches the rest of the wall panels.

MATERIALS & TOOLS:
-Marathon Tweed: bit.ly/4taQZoJ
-3M 90 Spray Adhesive: bit.ly/4sBwguh
-Small Roller: amzn.to/3NQJSmj
-Small Pull Saw: amzn.to/41cVWBC
-Ryoba Japanese Pull Saw: amzn.to/41MfAEI
-CA Glue (super glue): amzn.to/48cfnOK
-CA Glue Accelerator: amzn.to/47EJnTf

I didn't show how to remove the plastic clips that hold the blobs in place, but using a trim clip pulling tool like this one linked below is handy for that task.
-Trim Removal Tools: amzn.to/3PNPj6m

CHAPTERS
00:00 Intro
02:48 Prepping for fabric
04:15 Applying fabric
05:46 Re-installing blobs

#VanBuild #FordTransit #VanLife