Uploaded May 2018 | Updated September 2026, 2 hours ago
So I finally did it. I mounted two of the slides together to make a guide that will also move sideways. This features is intended to make doing plunge cutting more user friendly vs previous method of loosening the slide bar and sliding the entire bar, guide assembly to get to the correct position for cutting the plunge line.
So I finally did it. I mounted two of the slides together to make a guide that will also move sideways. This features is intended to make doing plunge cutting more user friendly vs previous method of loosening the slide bar and sliding the entire bar, guide assembly to get to the correct position for cutting the plunge line.
