Monster Mill 08 - Joystick and Buttons #1 @Askjerry
Monster Mill 08 - Joystick and Buttons #1  @Askjerry
Uploaded February 2019 | Updated November 2026, 3 hours ago
When one of my subscribers asked about adding physisical control panel buttons to LinuxCNC... I thought it could not be done because of limited inputs... then I thought "outside-the-box" and considered a joystick.

I had uploaded this a number of years ago... and at the time i did not fully understand HAL...
forum.linuxcnc.org/38-general-linuxcnc-questions/29913-joy2key-using-a-usb-joystick-device

But now... I understand this enough to realize it is a better solution...
wiki.linuxcnc.org/cgi-bin/wiki.pl?Simple_Remote_Pendant
Thanks Big John T for the advice!
( Even if it took two years for me to catch on! )

Encoders are here: amazon.com/s?k=usb+joystick+encoders

Follow along with the full Monster Machine Playlist
youtube.com/watch?v=qGU7YePm9kc&list=PLa_L8q5vezBPTOTd_YeSeAih15dbWauiv

Be sure to subscribe and ring the bell to get notifications!

UPDATE: Joystick Encoder Pins askjerry.info/MONSTER/Joystick%20Pins.pdf

My plan for the next video: askjerry.info/MONSTER/Joystick%20Connections.pdf
Monster Mill 08 - Joystick and Buttons #1Eve and Jerry Again (2020)My Birthday at LAX 2019Live Stream with Askjerry... Testing my capability anf hoping to get some feedbackMoney Machine   Im not your ATMThe Umbrella IncidentLost LovePedernales Falls State Park - Andrea VadnerThe Drift and the Descent - A space songLEGO Stepper (28BYJ-48 and Stepsticks) Part 2Monster Mill - 05 Probe Routines #3July 2018 - Sneak Peek
Askjerry |

Monster Mill 08 - Joystick and Buttons #1

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER