Minilathe 3D printed ways [rails] protection and cleaner - improvement @TinC33
Minilathe 3D printed ways [rails] protection and cleaner - improvement  @TinC33
Uploaded January 2017 | Updated November 2026, 11 hours ago
I just buy a 3D printer and this is one of my first prints.
I make this mod in one afternoon but it's great, carriage runs so smooth as never befor and the ways are constantly clean and lubricated.
Juts time to time drop some oil through the hole and that's it.

You can download an STL file for printing from there:
thingiverse.com/thing:2024460


Music:
Audionautix, Heading West
Skladba Heading West izvajalca Audionautix je licencirana z licenco Creative Commons Attribution (creativecommons.org/licenses/by/4.0/)
Izvajalec: audionautix.com
Minilathe 3D printed ways [rails] protection and cleaner - improvementHow to install vice/vise on miling table at a right angle [parallel]BlitzWolf BW-JS1 Portable Car Jump Starter / power bank 12000mAh 800A [starting tractor] only$44.99First test of TAROT T-2D brushless gimbalMaking my logo in 3D - 3D printed and paintedGorA RockA festival 2014 posnetki iz zrakaHow to connect any 3s LiPo battery on DJI Osmo / battery extensionAnother way How to drill a hole through a round bar in perfect center [middle]Xiaomi Roborock ERROR 1 Easy Fix & deep cleaningOrtur Laser Master 2 Pro - LU 2-4 [unbox / review / first test] + air assist stl filesExtruder calibration on geeetech i3 pro b 3D printerTBS Discovery, Tarot T-2D brushless gimbal & GoPro 3 black
TinC33 |

Minilathe 3D printed ways [rails] protection and cleaner - improvement

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER