Uploaded July 2020 | Updated September 2026, 3 hours ago
At this point, I've essentially recreated the RC2014 Micro hardware on a breadboard, and then downclocked it to 19kHz, so the serial port runs at 300 baud and it's easier to visually see what's going on with the LEDs on all the signal and bus lines.
At this point, I've essentially recreated the RC2014 Micro hardware on a breadboard, and then downclocked it to 19kHz, so the serial port runs at 300 baud and it's easier to visually see what's going on with the LEDs on all the signal and bus lines.
