Uploaded August 2018 | Updated November 2026, 3 days ago
➤Don't forget to subscribe ! bit.ly/SubscribeJMSpeedshop
➤Website: jmspeedshop.com
➤instagram: instagram.com/johanmuter
for the full project visit JMSpeedshop.com or look in the playlist
so the last modification is done to the chassis
on the steering axle side i removed a piece and welded a plate back
in so i have more room to route the downpipes on the driverside for the manifold to under the car
i also replaced the a piece of the engine bay wiring loom
the part for the headlamp on the passenger side was internally burnt because of a fault in the loom
i have replaced this section with a oem piece of a junkyard car
after this i removed the complete wiring loom from the engine bay
to remove the loom you need to disconnect the plugs on the inside of the car from the fuse box
and anothere 3 plug that are placed on the firewall
also the window wipermotor is connected with a plug in the fuse box on the underside
what i think is a weird placement because you can not reach the plug when the fusee box in place
when i removed the loom i labeled all the othere connectors
to make sure i know the located when i needs be installed again
next is the repair on the driverside wheel arch and coating the inside . also grit blast the inside engine bay and paint the inside of the engine bay
for questions just aks
JMSpeedshop.com
Music by Andrew Applepie
andrewapplepie.com
youtube.com/andrewapplepie
andrewapplepie.bandcamp.com
and music by MAXWELL - i love
➤Don't forget to subscribe ! bit.ly/SubscribeJMSpeedshop
➤Website: jmspeedshop.com
➤instagram: instagram.com/johanmuter
for the full project visit JMSpeedshop.com or look in the playlist
so the last modification is done to the chassis
on the steering axle side i removed a piece and welded a plate back
in so i have more room to route the downpipes on the driverside for the manifold to under the car
i also replaced the a piece of the engine bay wiring loom
the part for the headlamp on the passenger side was internally burnt because of a fault in the loom
i have replaced this section with a oem piece of a junkyard car
after this i removed the complete wiring loom from the engine bay
to remove the loom you need to disconnect the plugs on the inside of the car from the fuse box
and anothere 3 plug that are placed on the firewall
also the window wipermotor is connected with a plug in the fuse box on the underside
what i think is a weird placement because you can not reach the plug when the fusee box in place
when i removed the loom i labeled all the othere connectors
to make sure i know the located when i needs be installed again
next is the repair on the driverside wheel arch and coating the inside . also grit blast the inside engine bay and paint the inside of the engine bay
for questions just aks
JMSpeedshop.com
Music by Andrew Applepie
andrewapplepie.com
youtube.com/andrewapplepie
andrewapplepie.bandcamp.com
and music by MAXWELL - i love










