Mean Time Between Failure (MTBF) Explained. @Micro-Measurements
Mean Time Between Failure (MTBF) Explained.  @Micro-Measurements
Uploaded April 2022 | Updated November 2026, 20 hours ago
It’s common to hear unqualified statements that strain gauges fail or fall off. This can lead to rumours that gauges are unreliable, but in fact installation failures are caused by insufficient planning, incorrect products or procedures, poor workmanship, a lack of understanding, incomplete information, or environmental attack not considered when defining the specification. Installation life can be reasonably predicted and therefore maximised though good practice.

Life in excess of 30 years can be achieved by following these simple steps:

1. Understand the specification of the test – material to bond to, installation and operational environment, strain level and number of cycles. This will enable you to select the appropriate products and processes.

2. Select the proper surface preparation technique – refer to our surface preparation bulletin, B-129.

3. Follow the adhesive instructions carefully – storage (shelf and pot life), mixing, application, clamping and cure/postcure requirements.

4. Correct use of a soldering iron to avoid dry joints, keep joints as small as possible, and thorough cleaning of the flux residue upon completion.

5. Ensure that the appropriate protective coating adheres to the installation by ensuring it’s clean, and overlap the adhesive line by at least 20mm if space allows. Etch or prime leadwires for optimal bonding.

6. Thorough visual inspection at every stage, looking for lumps or voids in the adhesive, solder spikes/dry joints, contamination, cable anchoring, coating integrity. If in doubt, start again!

7. Robust electrical tests – resistance/deviation, insulation in excess of 10Gohms, stability at load and excellent zero return. Do this before and after applying the protective coating.

8. Inert gas purge and hermetic sealing is recommended for the best guarantee of long life in extreme environments.

Micro-Measurements: micro-measurements.com

Advanced Sensors Technology: micro-measurements.com/advanced-sensors-technology
Mean Time Between Failure (MTBF) Explained.How to test a frisbee (Disc golf)?Portable Strain Gage Welding Unit (60 Welds per 60 Seconds).How to pick the right soldering iron tip?How do you trust a carabiner with your life? 🧗‍♀️Full (Wheatstone) Bridge – Bending.What Makes a Strain Gage Load Cell So Accurate?Strain Gauge Construction.Full (Wheatstone) Bridge – Poisson Tension Cell.Strain Gage Installation Tutorial (350/5000 Ohm) - Part Two (Soldering)Can I Shunt Calibrate The Active Strain Gage At The Instrument?Diaphragm Sensors (Pressure Sensing?)
Micro-Measurements - a VPG Brand |

Mean Time Between Failure (MTBF) Explained.

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER