LPPFusion | Making the Electrical Connection Between the Tungsten Cathode and the Steel Connector Plate @LPPFusion | Uploaded 7 years ago | Updated 21 hours ago
Fusion Experts Urge Much Higher Funding for LPPFusion - https://lppfusion.com/fusion-experts-urge-much-higher-funding-for-lppfusion/
LPPFusion team members connected the new tungsten cathode to a steel connector plate in a number of steps First, Ivy Karamitsos rolled indium, a soft metal on top of the microcracks in the tungsten. This provided an alternate path for the current. Then Eric Lerner and Ivy measured the resistance with a micro-ohmmeter, confirming that it was low enough. Next Ivy, Eric and Mark Klepheke rolled indium onto the entire rim of the tungsten and to a groove in the steel plate. When the two pieces were bolted together, the indium squashed together into a low-resistance contact. Again, micro-ohmmeter measurements showed where resistance was still too high and the bolts had to be tightened. In the end, low resistance was secured everywhere.
Fusion Experts Urge Much Higher Funding for LPPFusion - https://lppfusion.com/fusion-experts-urge-much-higher-funding-for-lppfusion/
LPPFusion team members connected the new tungsten cathode to a steel connector plate in a number of steps First, Ivy Karamitsos rolled indium, a soft metal on top of the microcracks in the tungsten. This provided an alternate path for the current. Then Eric Lerner and Ivy measured the resistance with a micro-ohmmeter, confirming that it was low enough. Next Ivy, Eric and Mark Klepheke rolled indium onto the entire rim of the tungsten and to a groove in the steel plate. When the two pieces were bolted together, the indium squashed together into a low-resistance contact. Again, micro-ohmmeter measurements showed where resistance was still too high and the bolts had to be tightened. In the end, low resistance was secured everywhere.