Making Clamps for Machine Vice on the Mill Part 2 @jonsworkshop

Making Clamps for Machine Vice on the Mill Part 2 @jonsworkshop

Uploaded July 2020 | Updated September 2026, 2 weeks ago

Part 2 of the clamps for the new mill. A long episode, apologies, I didn't want to split it up into 3 to keep some continuity. A surprise ending!

Making Clamps for Machine Vice on the Mill Part 2

Cormak 4 x 6 Bandsaw - Vertical Table Build

Cormak ZX 7045 Mill Head Strip Part 4

Making a Flame Licker Engine Marc by Jan Ridders Part 11 - Piston & Fork

Making a Flame Licker Engine Marc by Jan Ridders. Part 10 - Cylinder & Head Part 2

Making A Toolmakers Vice From Scrap

Atlas 7B Shaper Refurb Part 4 - New Paint

Fitting A DRO To The Cormak ZX 7045 Mill X Axis Part 4

Fitting A DRO To The Cormak ZX 7045 Mill Z Axis Part 1

Making A Tap Follower

Making A Steel Tongue Drum From Two Woks! #Homemade #Tonguedrum #Handpan

Fitting A DRO To The Cormak ZX 7045 Mill Y Axis Part 1

Jons Workshop |

Making Clamps for Machine Vice on the Mill Part 2