Making a Flame Licker Engine Marc by Jan Ridders Part 11 - Piston & Fork @jonsworkshop

Making a Flame Licker Engine Marc by Jan Ridders Part 11 - Piston & Fork @jonsworkshop

Uploaded January 2022 | Updated September 2026, 2 weeks ago

We are nearing the end of the manufacturing stages on this engine now. This is the last key critical sub assembly as we get the piston made.

Channel artwork: Ryan Toomey

Making a Flame Licker Engine Marc by Jan Ridders Part 11 - Piston & Fork

Making a Flame Licker Engine Marc by Jan Ridders. Part 10 - Cylinder & Head Part 2

Making A Toolmakers Vice From Scrap

Atlas 7B Shaper Refurb Part 4 - New Paint

Fitting A DRO To The Cormak ZX 7045 Mill X Axis Part 4

Fitting A DRO To The Cormak ZX 7045 Mill Z Axis Part 1

Making A Tap Follower

Making A Steel Tongue Drum From Two Woks! #Homemade #Tonguedrum #Handpan

Fitting A DRO To The Cormak ZX 7045 Mill Y Axis Part 1

My New Harrison M300 - Initial Strip & Clean Part 1

Workshop Tips #14 - DRO PCD Function Explained

Workshop Blether #1

Jons Workshop |

Making a Flame Licker Engine "Marc" by Jan Ridders Part 11 - Piston & Fork