Uploaded April 2025 | Updated November 2026, 3 hours ago
As promised part 2 of the magnet trepanning tool. In this video we get to see behind the scenes at the magnet development program support shop. This tool was created to remove Stycast epoxy from the bore of a CCT (Canted Cosine Theta) superconducting magnet, Special thanks to the PI Xiaorong and scientific technician Andy for allowing me to shoot some video of them using the tool I built.
As promised part 2 of the magnet trepanning tool. In this video we get to see behind the scenes at the magnet development program support shop. This tool was created to remove Stycast epoxy from the bore of a CCT (Canted Cosine Theta) superconducting magnet, Special thanks to the PI Xiaorong and scientific technician Andy for allowing me to shoot some video of them using the tool I built.










