Magnet motor homopolar homemade @ElectricExperimentsRobert33
Magnet motor homopolar homemade  @ElectricExperimentsRobert33
Uploaded February 2016 | Updated November 2026, 3 hours ago
This homopolar motor system is very easy to realize, it comprises a coil of wire, a wooden base and a magnet.
DESCRIPTION MATERIAL:A coil of copper wire of 0.40 mm. 180 laps, total diameter 90 mm.Two small aluminum segments, made with a sheet of a can of coke.The aluminum segments are 12 mm. x 8 mm. and detached from each other by 2 mm. and then glued with hot glue on the wood. The remaining part of the wood goes to housing on a semicircular support, made with an iron sheet, it is obtained from a jar for foods.The two brushes are made with very soft electric wire.Two simple speaker magnets, the size ranges from 50-60 mm.
Two 9 volt batteries connected together in parallel.
* The end of the wire of the coil must be cleaned from insulating paint and put one for each segment. It must do this before pasting the the segments to the wood.
Magnet motor homopolar homemadeAn old experiment did not go wellEnergy salt water battery testMagnet rotor levitation easy homemadeFidget spinner pushed by an electromagnetic coilThree water heating systems in comparisonHigh Voltage Microwave Transformers MOT ExperimentHigh voltage electric pinwheel testMagnets and current Generator with rotating Electric MotorSmall alternator 220 volts & motor generatorElectric Boat without batteries, test in seaElectrolytic Capacitors in Short Circuit explosions
Experiments Robert33 |

Magnet motor homopolar homemade

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER