skmetal7 | maching exhaust profile @skmetal7 | Uploaded 14 years ago | Updated 3 hours ago
4300rpm 10ipm i could have ran faster, but the part wasnt held down the best. tough part to hold. i needed it to stay in place, since i was going to do a 3d toolpath later, i knew i wouldnt be able to rezero the part well enough for the 3d path to blend the contour and not have some offset.
had to make that jig for the three different mounting methods
4300rpm 10ipm i could have ran faster, but the part wasnt held down the best. tough part to hold. i needed it to stay in place, since i was going to do a 3d toolpath later, i knew i wouldnt be able to rezero the part well enough for the 3d path to blend the contour and not have some offset.
had to make that jig for the three different mounting methods
