CRG | Let's finish the GBS8200 in Amiga 2000 EATX @CRG | Uploaded November 2023 | Updated October 2024, 13 hours ago.
A couple of months ago I built a GBS Control mod onto a GBS8200 but also mounted it to a board so it could be installed within the Amiga 2000 EATX. On the day I left it with just a VGA cable hanging out the back of the case and while it works fine it left it very unfinished. Let's finally finish off the install by soldering on a VGA cable and printing a custom bracket to hold the card in place.
My bracket can be downloaded here - thingiverse.com/thing:6289625
The original GBSControl mod video - youtu.be/QJ3ZAn1Q7Os?si=1M9SWJ6CDWuKpQ2A
Chapters
00:00 Intro
00:36 Look what I found
01:19 What goes where?
03:48 Soldering
04:34 Test fitting
06:04 Does the video still work?
07:01 3D printed bracket
09:01 Conclusion
A couple of months ago I built a GBS Control mod onto a GBS8200 but also mounted it to a board so it could be installed within the Amiga 2000 EATX. On the day I left it with just a VGA cable hanging out the back of the case and while it works fine it left it very unfinished. Let's finally finish off the install by soldering on a VGA cable and printing a custom bracket to hold the card in place.
My bracket can be downloaded here - thingiverse.com/thing:6289625
The original GBSControl mod video - youtu.be/QJ3ZAn1Q7Os?si=1M9SWJ6CDWuKpQ2A
Chapters
00:00 Intro
00:36 Look what I found
01:19 What goes where?
03:48 Soldering
04:34 Test fitting
06:04 Does the video still work?
07:01 3D printed bracket
09:01 Conclusion