Uploaded March 2018 | Updated November 2026, 3 hours ago
Welcome back folks,
This is Part One of a series documenting the restoration process of my vintage metal working lathe, this is a Zyto Brand. these were manufatured in the Uk from around the 1930's
In Part one i remove the tail stock and strip it of all componant parts, degrease, remove the old paint, wire brush and rebuild.
Whilst this is not a sponsered build i would like to give a shout out to Wilkos Paint and Varnish remover - for £3 It works like a dream as you can see. i will leave a link below..
goo.gl/Xo4cmR
Makers Media Network Public Facebook Page
facebook.com/MakersMediaNetwork
Makers Media Network You tube Channel
youtube.com/channel/UCbjYrhnIA3p1G6h15QCEidg
Thanks for watching
Welcome back folks,
This is Part One of a series documenting the restoration process of my vintage metal working lathe, this is a Zyto Brand. these were manufatured in the Uk from around the 1930's
In Part one i remove the tail stock and strip it of all componant parts, degrease, remove the old paint, wire brush and rebuild.
Whilst this is not a sponsered build i would like to give a shout out to Wilkos Paint and Varnish remover - for £3 It works like a dream as you can see. i will leave a link below..
goo.gl/Xo4cmR
Makers Media Network Public Facebook Page
facebook.com/MakersMediaNetwork
Makers Media Network You tube Channel
youtube.com/channel/UCbjYrhnIA3p1G6h15QCEidg
Thanks for watching










