Installing a 2 post lift - inside a low shed @peugeotCitroen2CV
Installing a 2 post lift - inside a low shed  @peugeotCitroen2CV
Uploaded July 2018 | Updated November 2026, 3 days ago
I have never been a fan of climbing under cars to do work on them, even with axle stands the limited space feels claustrophobic, in the winter the concrete is cold and getting bits of dirt and rust into the eyes is a nuisance. Also for doing repair videos it is very hard to set the camera up for decent footage under a car.

At the moment my shed is an old mushroom house, basically a polytunnel but with a layer of insulation and unfortunately windows. It is about 3 meters high at its tallest point but being a semicircle in shape it is not suitable for most 2 post lifts.

After visiting a few places using other types of lift i decided that i still wanted a 2 post lift as a cousin has a 2 post lift which i have used in the past. I considered building one myself but after drawing one up and costing the materials, and time required it seemed cheaper to buy one. Car mechanics magazine advertises a company called CJ autos which makes garage equipment and they were selling the CL07
https://www.cjautos.eu/product_p/cl07.htm

The lift is a lower than normal 2 post lift designed for sheds with limited ceiling height. Despite being a smaller lift this cost more than standard height lifts, less material but perhaps the rules of supply and demand dictate this price. Instead of cables or chains connecting the two posts this lift uses an equalising valve to keep the two posts level relative to each other. It took a bit of time to get them to level up but the instructions covers this.

I had to get the hydraulic lines adjusted to suit how i was using this lift, and that highlighted an issue, the hydraulic fittings do not seem to be standard BSP fittings or of a type that seem to be on the shelf in the UK, i believe the power unit has originated from china. I was able to get the pipes cut and extension pieces crimped in using standard crimp connections. It would be better if the lift used standard fittings though should anything need repaired in the future. I work for a company that makes machines with hydraulics and a quality UK spec replacement power unit would be between £100-£200 for this lift

With a lifting capacity of 3000Kg this lift seems able to lift most cars, so far i have lifted a 205, 305, 206, 406, Citroen Xantia and Volvo V70 on it with no issues. A Citroen Picasso is a bit taller and i had to ensure it did not hit the roof. I plan to wire in some sort of limit switch that will stop the lift if a cars roof goes past a certain point.
Installing a 2 post lift - inside a low shedHonda Jazz/Fit GE, Gearbox & Clutch ReplacementRenault 70 14 Tractor   Battery ReplacementRenault Clio III   Replacing Front Brake Disks and PadsRenault Clio 3 Service Light ResetKarting at Railway Karting in MoneymorePeugeot 407 Front bumper and front panels removalNissan Micra K12 Engine Replacement | Part 1 - RemovalPeugeot 206 1.1 idle speed too highRenault Kadjar Door handle keyless entry button replacementCitroen Berlingo Battery ReplacementMazda 6 with Electric Parking Brake - Rear Brake Disks & Pads Replacement
peugeotCitroen2CV |

Installing a 2 post lift - inside a low shed

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER