Uploaded April 2013 | Updated November 2026, 6 hours ago
This is an excerpt from Lesson #6 in Paulson's Injection Molded Part Problems and Solutions training progam - Splay (or Silver Streaks) and how to fix them. Information on the complete injection molding problems and solutions training program can be found at:
paulsontraining.com/products/injection-moulded-part-problems-solutions
Splay in injection molded plastic parts is often caused by moisture in the plastic raw material. However, there can be other causes as well. This lesson teaches the whole range of cause and solutions to Splay problems. The employee is taught to look at the problem "from the plastic's point of view". By using this technique, injection molding troubleshooters can solve molded part defects like splay regardless of the plastic part design or the material being molded.
Here is a list of all of the 11 defects covered in the complete molding problems and solutions course: Voids, Sink Marks, Short Shots, Flash, Weld (Knit) Lines, Splay (Silver Streaks), Jetting, Burn Marks, Warp, Cracks and Part Breakage, and Controlling Molded Part Dimensions.
This is an excerpt from Lesson #6 in Paulson's Injection Molded Part Problems and Solutions training progam - Splay (or Silver Streaks) and how to fix them. Information on the complete injection molding problems and solutions training program can be found at:
paulsontraining.com/products/injection-moulded-part-problems-solutions
Splay in injection molded plastic parts is often caused by moisture in the plastic raw material. However, there can be other causes as well. This lesson teaches the whole range of cause and solutions to Splay problems. The employee is taught to look at the problem "from the plastic's point of view". By using this technique, injection molding troubleshooters can solve molded part defects like splay regardless of the plastic part design or the material being molded.
Here is a list of all of the 11 defects covered in the complete molding problems and solutions course: Voids, Sink Marks, Short Shots, Flash, Weld (Knit) Lines, Splay (Silver Streaks), Jetting, Burn Marks, Warp, Cracks and Part Breakage, and Controlling Molded Part Dimensions.










