In limit state design, factor of safety is applied mainly to: @ENGINEERINGTACTICS
In limit state design, factor of safety is applied mainly to: @ENGINEERINGTACTICS
Uploaded June 2026 | Updated September 2026, 1 week ago
In limit state design, factor of safety is applied mainly to:

A) Loads only
B) Materials only
C) Both loads and materials
D) Span of structure

✅ Correct Answer: C) Both loads and materials
In limit state design, factor of safety is applied mainly to:How to calculate material for 1 cubic meter of concrete | Engineering TacticsHow to calculate cutting length of Bentup bar - Part 3How to measure farma in liters | what is farma and their uses | Engineering TacticsIndian Navy Musician Recruitment 2021 | Engineering TacticsTypes of OPC Cement | OPC 33, 43 & 53 Grade | Uses & Most Commonly Used | Engineering tacticsWhy we are add 0.42D for calculating Cutting length of Bent up bar in Slab | Engineering TacticsLearn how to calculate the cutting length of helical stirrups for a circular pile0 to 100k Subscribers Journey | Special video on 100k Subscribers | Engineering TacticsClassification of Steel Bars Used in Construction | MS, HYSD & TMT Bars | Fe 250, 415, 500, 550How to break column | Engineering TacticsWhich defect occurs due to excessive water in concrete? #engineeringtactics
ENGINEERING TACTICS |

In limit state design, factor of safety is applied mainly to:

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER