Uploaded May 2021 | Updated September 2026, 43 minutes ago
In this video, I make an Industrial Style Shelf Bracket with a rebar support. I love the look of industrial furniture and all the decor that comes with it, and this shelf bracket has the look I like. A nice MIG Welding Project using rebar
I hope you enjoy my video of the rebar shelf bracket project. It was a lot of fun to make. I did make other brackets exactly the same, so I could hang the shelves. I am now thinking of making two much smaller ones of the same style, to put a small shelf on the wall below these shelves.
The flat bar is 43mm wide, 220mm long on each side of the bracket, and 3mm thick. The small rebar is 7mm, and the large is 13mm.
The main tools used were a MIG welder, angle grinder, drill, and bench vise.
The Brand of the Drill bits and cutting/flap discs is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely. I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.
In this video, I make an Industrial Style Shelf Bracket with a rebar support. I love the look of industrial furniture and all the decor that comes with it, and this shelf bracket has the look I like. A nice MIG Welding Project using rebar
I hope you enjoy my video of the rebar shelf bracket project. It was a lot of fun to make. I did make other brackets exactly the same, so I could hang the shelves. I am now thinking of making two much smaller ones of the same style, to put a small shelf on the wall below these shelves.
The flat bar is 43mm wide, 220mm long on each side of the bracket, and 3mm thick. The small rebar is 7mm, and the large is 13mm.
The main tools used were a MIG welder, angle grinder, drill, and bench vise.
The Brand of the Drill bits and cutting/flap discs is "Alpha" If you can't get them at your local hardware shop, here is a link to Alpha Tools: https://alphatools.com.au
►►Subscribe to our Channel for more videos ►► bit.ly/2ULxLJogavinclark
Always use all the correct safety gear, and use your tools safely. I am not a good role model for this.
Hope you found something of use in my video or at least found it entertaining.
Gavin Clark DIY
Note: When you bend metal/rebar, you naturally weaken it. Bending it cold will normally cause fine cracks, and it may even break if you put enough strain on the rebar or bend it in the same place too many times. Do not rely on cold-bent steel/rebar to support a load.
