I made a bridge/hump for my track. @tahustvedt
I made a bridge/hump for my track.  @tahustvedt
Uploaded June 2021 | Updated September 2026, 4 hours ago
I made this hump thingy for my track today from some repurposed steel and some wood. It's very heavy and strong. It can work as a bridge or just a big hump. I tried it as a bridge. I thought it would be hard to drive because of the visibility but when I stand here it's fine to drive through. If I stand on the bank where I have stood before then it's not good. I want to make a small driver's stand where I'm standing in this video. The sun will get in my eyes sometimes but I can always move to the bank if I feel like it. The video was shot at 22:00 in the evening so that's why it's darker than usual.
I made a bridge/hump for my track.Innekjøring på Fagerlidal Skole 24.07.2021Maiden flight with my fourth big EL-39 3D-printed jet - I almost crashed itTamiya RX-7 first time drive - Stock M-06 chassisUltra light Nucking Futs - Printed from LW-PLATamiya Fire Dragon/Terra Scorcher 3D Printed Rear Hub UpgradeBadger 3D Printed FWD RC BuggyComparison between the input lag of an Amico and other consolesRobin Flies His Freewing Jets At Senja MFKFreewing F-16 formation flying/failingApple IIe joystick adapterI can finally play Doom Eternal on my Amiga!
Grumpy RC Modeler |

I made a bridge/hump for my track.

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER