Badger 3D Printed FWD RC Buggy @tahustvedt
Badger 3D Printed FWD RC Buggy  @tahustvedt
Uploaded May 2021 | Updated September 2026, 17 minutes ago
First time driving my Badger around my track. The last of the snow melted yesterday so I can finally drive my track again.

It has a tendency to nose forward when jumping but it can be opposed with throttle. It also tends to nose over when I brake hard so I need to turn down the brake force in the ESC. It has incredible front tracktion while braking because of the forward weight balance after all.

The body has warped because I only painted the outside, and it's a thin wall print, so it rubbed against the front wheels in hard corners. I fixed it after the video by heating and squeezing the sides in. I might add velcro along the sides of the chassis to hold the boy in and keep dirt out.
Badger 3D Printed FWD RC BuggyComparison between the input lag of an Amico and other consolesRobin Flies His Freewing Jets At Senja MFKFreewing F-16 formation flying/failingApple IIe joystick adapterI can finally play Doom Eternal on my Amiga!Lots of EL-39 electric jet flying - Spent over 3 hours at the fieldGleichauf F-16 - Big Ducted Fan Jet From The Mid 1990sGleichauf 1:8 F-16 in grey weather and wind.Volvo855 Indoor practice - 16.10.2021On board EL-39 EDF jet flight videoLightened and modified LX F-35A
Grumpy RC Modeler |

Badger 3D Printed FWD RC Buggy

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER