Humid and mouldy! Installing MVHR ventilation (Kair system) @GosforthHandyman
Humid and mouldy! Installing MVHR ventilation (Kair system)  @GosforthHandyman
Uploaded September 2023 | Updated September 2026, 1 week ago
The studio room was getting quite dangerous. Without proper ventilation we were getting mould problems to add to the CO2 issues. So we installed a Kair K-HRV150 MVHR system.

How did I fix the soundproofing issue? On the Member Zone here:
members.gosforthhandyman.com/soundproof-mvhr-vent

Don't forget to follow on X / Twitter:
https://x.com/gosforthandy

Here's an affiliate link to the Kair system I'm using:
amzn.to/3ESfTlQ

Join the Gosforth Handyman mailing list:
gosforthhandyman.com/newsletter

Not bothered about extra stuff? Support the channel via Patreon:
patreon.com/gosforthhandyman

Official merch including Gosforth Handyman tape measure:
gosforthhandyman.com/shop

TOOLS & PRODUCTS I USE: gosforthhandyman.com/products-i-use
INSTA: instagram.com/gosforthhandyman
CORRECTIONS: gosforthhandyman.com/corrections

All content on this channel is exclusively owned by MacLellan Creative Limited. Copyright (c) 2023. All rights reserved.

MVHR chapters:
00:00 - Introduction
01:50 - MVHR overview
04:20 - Where to put the hole
06:05 - Drilling a big hole
10:45 - Installing the duct pipe
14:10 - Control unit
15:40 - Painting and nice music
16:55 - How it works
22:00 - Is the room still soundproof?

I sometimes use affiliate links - these don’t cost you a penny and help to keep this channel going. Read more about affiliate links here - the fairest way of funding the internet: gosforthhandyman.com/affiliate-links - thanks so much for your awesome support!

#soundproofing #mvhr #ventilation
Humid and mouldy! Installing MVHR ventilation (Kair system)How I build some simple timber raised bedsRestoring 100 year old doors - what’s hidden under the hardboard?? (part 1)6 years later - is this petrol wood chipper actually any good?How I make a SIMPLE DIY fenceMaking BIG HOLES in very hard brick wallsWere about half way there! (1920s Renovation Part 24)Time for the first knock-through of our self-build extension!How to fit curtain tracks & rails? Do you need a wooden batten?How I fit decorative END PANELS on kitchen unitsWorking with wonky walls... and first fix plumbing - utility room projectMakita DTD146 vs DeWalt DCF887 impact driver
Gosforth Handyman |

Humid and mouldy! Installing MVHR ventilation (Kair system)

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER