HPIGUY | ImmersionRC Vortex Setup - Sbus - CPPM - End Points @ThatHPIGUY
HPIGUY | ImmersionRC Vortex Setup - Sbus - CPPM - End Points  @ThatHPIGUY
Uploaded May 2015 | Updated November 2026, 3 hours ago
During the setup on the ImmersionRC Vortex I came across a few things that no one else mentioned in a video. I thought I would show you my mistakes and how I fixed them. I could not get the OSD to appear for some reason but it turned out to be the end points on channels 1.2.3.4. A quick check and calibration through cleanflight had me up and running.

Remember to set the end points in the radio. To do this (on the trottle for example):

Power everything on
Plug into PC/Mac and run cleanflight
Click on the Receiver tab
Push the trottle up, if it does not reach 2000 then change the End point on the radio until it reaches 2000. Then put the throttle down, it should be at 1000, if it is not adjust the end point until it is.

Repeat for the YAW ELE AIL.

Download Cleanflight (in google chrome) chrome.google.com/webstore/detail/cleanflight-configurator/enacoimjcgeinfnnnpajinjgmkahmfgb?hl=en

My Instagram: instagram.com/that_hpi_guy

My Facebook: facebook.com/ThatHpiGuy

Donate to keep the channel going: goo.gl/pFQDBj

Thanks for watching.
HPIGUY | ImmersionRC Vortex Setup - Sbus - CPPM - End PointsHPIGUY | QAV250 Aero Guard = 180 Yaw ProblemHPIGUY | Sunday 180 Session - Frozen Thumbs - BabyBEE 18HPIGUY | XHover MXP230 ELITE - Part 1 - Thoughts and BuildHPIGUY | Industrial Factory Fire in Bromborough - Drones view - WirralHPI GUY | I Dont Normally Freestyle - TSX220 FPVHPI GUY | XJaguar Build & Setup VideoHPI GUY | Runcam SPLIT MINI - FPV & HD CameraHPIGUY | DJI Inspire1 & Remote Firmware Upgrade - Update -How ToHPIGUY | Vortex Pro Maiden Flight - Airmode - DVR footageHPI GUY | 1 Minute Video - Blowing Off Some SteamHPIGUY | MY DJI Fly Away - Comedy short
ThatHPI GUY |

HPIGUY | ImmersionRC Vortex Setup - Sbus - CPPM - End Point's

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER