How to use Fusion360 from the Perspective of an AutoDesk Inventor User Part 4 @PatrickHoodDaniel
How to use Fusion360 from the Perspective of an AutoDesk Inventor User Part 4  @PatrickHoodDaniel
Uploaded February 2017 | Updated November 2026, 2 days ago
Check out the official site that produces these videos (and get your fabrication on!):
buildyourcnc.com

The CAMing of the parts is continued.

Equipment that I use to make videos:
Canon EOS Rebel: amzn.to/2rJSeh0
Macro Lens: amzn.to/2qaSKmK
Microphone: amzn.to/2qO2RB4
3D Mouse to rotate/zoom/move the object (Must have for CAD!!!): amzn.to/2ruFnSn
The drafting pencil I use on these videos: amzn.to/2qioYg2
The cheap oscilloscope that I use (because it's cheap and will work all of the projects in these tutorials): amzn.to/2rSHnBa
A better oscilloscope and the one I would recommend: amzn.to/2qizK5M
The brand of multimeter that I use and the one I recommend: amzn.to/2qicUez


Want to have your own Patreon campaign? patreon.com/invite/wpllxz
How to use Fusion360 from the Perspective of an AutoDesk Inventor User Part 41. Pokeys57CNC CNC Interface and Controller IntroductionLets Demystify the ATC Spindle! Part 1: Introduction33. How to Setup ADC Circuit / Prep for 1st ADC Program - STM32 ARM Microcontroller - Part 1Autodesk Inventor: Sharing Parameters Between Parts47. How to Control the PWM Output with the ADC and a Potentiometer  - STM32 ARM Microcontroller45. How to: Edge Aligned PWM (Pulse Width Modulation) Signal Part 3 - STM32 ARM MicrocontrollerEpic 6-Hour CNC Electronics Retrofit Crushed into 14 Mins: The Ultimate DIY Overhaul!Watch Me Build Closed-Loop CNC Electronics in 25 Minutes1) STM32 ARM Microcontroller Series IntroductionPokeys57CNC and Mach4 Part 1: Software Installation, Connect to Power and Test Software ConnectionLast Daily Live Stream. Discord: https://buildyourcnc.com/discord
BuildYourCNC |

How to use Fusion360 from the Perspective of an AutoDesk Inventor User Part 4

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER