Watch Me Build Closed-Loop CNC Electronics in 25 Minutes @PatrickHoodDaniel
Watch Me Build Closed-Loop CNC Electronics in 25 Minutes  @PatrickHoodDaniel
Uploaded July 2022 | Updated November 2026, 2 days ago
This is a complete build of a closed-loop CNC electronics system.

Links to tools and items mentioned in the video:
1/4" Rivet nuts: amzn.to/3Ru0PQv
The multi tool I use to cut my holding tabs: amzn.to/3bZkCXP
Small piece holder for the router to keep your fingers intact: amzn.to/3nTARsd
Terminal Crimper (Klein Tools): amzn.to/3uElSWT
Wire stripper: amzn.to/3Poxup3
Wire ferrules and crimper: amzn.to/3yTEYuG
DeWALT Shop-vac: amzn.to/3ar9oLv

If you need help with your CNC electronics, give us a call. Go to:
buildyourcnc.com/products/sub-assemblies-Technical-support-token?utm_source=youtube&utm_medium=video&utm_campaign=V8AbINDRLh4

Mach3 CNC Control Software:
buildyourcnc.com/products/control-SOFTWARE-mach3?utm_source=youtube&utm_medium=video&utm_campaign=V8AbINDRLh4
This is the software I use with my CNC router.

The greenBullv2 60 degree 4'x8' CNC Router:
buildyourcnc.com/products/cnc-machine-greenbullv2-milling-laser?utm_source=youtube&utm_medium=video&utm_campaign=V8AbINDRLh4

This CNC router that I use in my shop is my favorite as it can also house a laser gantry and is a great space saver. It takes up the same amount of space as a typical 4'x8' machine, but it is intended to be pushed up against a wall so only one side of the machine needs to be accessed.

All of these machines and software can be purchased at BuildYourCNC.com
buildyourcnc.com/?utm_source=youtube&utm_medium=video&utm_campaign=V8AbINDRLh4
Watch Me Build Closed-Loop CNC Electronics in 25 Minutes1) STM32 ARM Microcontroller Series IntroductionPokeys57CNC and Mach4 Part 1: Software Installation, Connect to Power and Test Software ConnectionLast Daily Live Stream. Discord: https://buildyourcnc.com/discord8) ARM STM32 Microcontroller Tutorial Change the Internal Clock Speed! Using CubeMX and Register58. How to: I2C Circuit and Initialization - ARM STM32 Microcontroller TutorialLaser Controller Trocen AWC708C Setup Part 2Customer Plasma Electronics (Internal - For Reference Only)57. I2C How to. An introduction to the I2C Protocol for the ARM STM32 Miorcocontrollers - Tutorial59. How to Use I2C to Read a Devices Register Part 1 - ARM STM32 Microcontroller Tutorial31. How to Set the cursor Location on the LCD on the ARM MCU - Part 18#3 ARM STM32 Microcontroller Tutorial - Installing the IDE and Monitoring Software
BuildYourCNC |

Watch Me Build Closed-Loop CNC Electronics in 25 Minutes

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER