Uploaded February 2019 | Updated November 2026, 9 hours ago
How to take the body measurements for a custom yoke pullover or cardigan, starting from the body and a gauge swatch. Shown on both a man and a woman. This is in conjunction with the ITAG-Yoke tutorial. Circumferences are taken first, then lengths. Back-neck width is measured with a yarn around the neck and the two strands hanging parallel; measure the distance between them. Chest or bust is taken around the body, under the armpits. Once the tape is in place, the arms should be down — raising them changes the measurement — and the tape should sit reasonably parallel to the floor. Waist can be found by bending a little from side to side and measuring at the bend; that helps when the waist is hard to see. Hip circumference is taken where the sweater should end, which is a preference, not a fixed anatomical point. Then measure the upper arm and the wrist. Armhole depth is measured with a straight ruler or a large knitting needle held comfortably high in both armpits, from one end over the top of the shoulder to the other end. The tool does not have to be parallel to the floor; the total is divided in half later. Lengths start from the bump at the back neck: down to a string at the waist, then down to the hem (the tape hangs straight, not in at the waist, because the sweater will hang fairly straight). The front length is taken from that same back-neck point, around to the front, down to the hem. Arm length is from the back neck, over the shoulder and elbow, to the wrist, with the arm bent and the hand on the hip; the wearer can mark the sleeve length. For a woman’s schematic, also measure bust-point width, and the depth from the shoulder down to the bust points, if bust shaping is planned.
Chapters
0:14 Introduction: measuring for a yoke pullover or cardigan
0:54 Back-neck width (man)
1:16 Chest, waist, and hip (man)
2:02 Upper arm and wrist (man)
2:13 Armhole depth (man; over the shoulder, divide later)
2:34 Back neck to waist, hem, and front hem (man)
3:36 Arm length (man)
4:04 Back-neck width (woman)
4:18 Bust, waist, and hip (woman)
4:56 Upper arm and wrist (woman)
5:09 Armhole depth (woman)
5:36 Back neck to waist, hem, and front hem (woman)
6:03 Arm length (woman)
6:22 Bust-point width and depth (for the schematic)
Related videos
- How to Take Body Measurements for a Custom Raglan Sweater: youtu.be/kNZ1WS63qwA
- How to Custom-Fit a Yoke When Bust and Arm Sizes Differ: youtu.be/EsggQilA5NI
- How to Compensate for a Bust vs Sleeve Size Discrepancy: youtu.be/AJywu6ECtIM
- How to Make a Sloper Prior to Knitting Your Sweater: youtu.be/w_Y5M9ht6cE
- How to Use Ann Budd for a Yoke: Measurements, Ease, and Gauge (Part 1): youtu.be/dC5W0pWWHQc
- How to Make a Gauge Swatch for a Sweater (Don't Round Your Stitch Gauge): youtu.be/0nECq0TZS8E
ITAG-Yoke KAL: ravelry.com/patterns/library/itag-yoke-kal
More on this topic: see my playlists "Sweater Construction & Finishing: Seaming, Pockets, Steeks, Weaving in Ends" and "ITAG-Yoke" on the channel.
Live Zoom classes (Bootcamps): masteryourknitting.com
If you enjoy my videos please subscribe and consider buying me a coffee on Ko-fi - ko-fi.com/suzannebryan
Where to find me -
Suzanne - Off the Cuff - youtube.com/channel/UCQBgFUvQzjz1RUm9NsgEA1A
Knitting with Suzanne Bryan on Ravelry - ravelry.com/groups/knitting-with-suzanne-bryan
Knitting with Suzanne Bryan on FB- facebook.com/groups/1769286026429876
KnittingSuzanne on Ravelry - ravelry.com/people/KnittingSuzanne
Blog: knittingsuzanne.com
#bodymeasurements #yokesweater #sweaterfitting #knitting #itag
How to take the body measurements for a custom yoke pullover or cardigan, starting from the body and a gauge swatch. Shown on both a man and a woman. This is in conjunction with the ITAG-Yoke tutorial. Circumferences are taken first, then lengths. Back-neck width is measured with a yarn around the neck and the two strands hanging parallel; measure the distance between them. Chest or bust is taken around the body, under the armpits. Once the tape is in place, the arms should be down — raising them changes the measurement — and the tape should sit reasonably parallel to the floor. Waist can be found by bending a little from side to side and measuring at the bend; that helps when the waist is hard to see. Hip circumference is taken where the sweater should end, which is a preference, not a fixed anatomical point. Then measure the upper arm and the wrist. Armhole depth is measured with a straight ruler or a large knitting needle held comfortably high in both armpits, from one end over the top of the shoulder to the other end. The tool does not have to be parallel to the floor; the total is divided in half later. Lengths start from the bump at the back neck: down to a string at the waist, then down to the hem (the tape hangs straight, not in at the waist, because the sweater will hang fairly straight). The front length is taken from that same back-neck point, around to the front, down to the hem. Arm length is from the back neck, over the shoulder and elbow, to the wrist, with the arm bent and the hand on the hip; the wearer can mark the sleeve length. For a woman’s schematic, also measure bust-point width, and the depth from the shoulder down to the bust points, if bust shaping is planned.
Chapters
0:14 Introduction: measuring for a yoke pullover or cardigan
0:54 Back-neck width (man)
1:16 Chest, waist, and hip (man)
2:02 Upper arm and wrist (man)
2:13 Armhole depth (man; over the shoulder, divide later)
2:34 Back neck to waist, hem, and front hem (man)
3:36 Arm length (man)
4:04 Back-neck width (woman)
4:18 Bust, waist, and hip (woman)
4:56 Upper arm and wrist (woman)
5:09 Armhole depth (woman)
5:36 Back neck to waist, hem, and front hem (woman)
6:03 Arm length (woman)
6:22 Bust-point width and depth (for the schematic)
Related videos
- How to Take Body Measurements for a Custom Raglan Sweater: youtu.be/kNZ1WS63qwA
- How to Custom-Fit a Yoke When Bust and Arm Sizes Differ: youtu.be/EsggQilA5NI
- How to Compensate for a Bust vs Sleeve Size Discrepancy: youtu.be/AJywu6ECtIM
- How to Make a Sloper Prior to Knitting Your Sweater: youtu.be/w_Y5M9ht6cE
- How to Use Ann Budd for a Yoke: Measurements, Ease, and Gauge (Part 1): youtu.be/dC5W0pWWHQc
- How to Make a Gauge Swatch for a Sweater (Don't Round Your Stitch Gauge): youtu.be/0nECq0TZS8E
ITAG-Yoke KAL: ravelry.com/patterns/library/itag-yoke-kal
More on this topic: see my playlists "Sweater Construction & Finishing: Seaming, Pockets, Steeks, Weaving in Ends" and "ITAG-Yoke" on the channel.
Live Zoom classes (Bootcamps): masteryourknitting.com
If you enjoy my videos please subscribe and consider buying me a coffee on Ko-fi - ko-fi.com/suzannebryan
Where to find me -
Suzanne - Off the Cuff - youtube.com/channel/UCQBgFUvQzjz1RUm9NsgEA1A
Knitting with Suzanne Bryan on Ravelry - ravelry.com/groups/knitting-with-suzanne-bryan
Knitting with Suzanne Bryan on FB- facebook.com/groups/1769286026429876
KnittingSuzanne on Ravelry - ravelry.com/people/KnittingSuzanne
Blog: knittingsuzanne.com
#bodymeasurements #yokesweater #sweaterfitting #knitting #itag







![Live with Suzanne 1/27/19
Time stamps for 1-27-19 live stream
3:58—Suzanne shows us her current Starry Starry Night socks (SSNS) in progress and the mistake she made in the first one. Suzanne also discusses the difference between main/contrasting color vs color dominance
13:04—should you alternate skeins of hand dyed yarn when working the brioche ribbing and buttonband?
14:15—finding the YouTube playlists
15:29—Suzanne also knows how to crochet!
15:48—BOOK: “Latviesa Cimdi” by Maruta Grasmane, English version “Mittens of Latvia”
17:57—BOOK: “Charts for Color Knitting” by Alice Starmore
20:33—what Suzanne listens to while she knits
21:59—fitting the SSNS pattern to a larger leg
25:27—substituting a stitch pattern into projects [make and link video?]
27:10—what yarn Suzanne used in her socks
28:13—corrugated ribbing question; purls
28:55—are the ITAG instructions complete?
29:36—stranded knitting with more than two colors per row/round
30:13—advice on adding colors to mittens
31:09—gussets on SSNS
33:43—double knitting videos
35:22—is Jamison & Smith jumper yarn good for socks?
37:29—Twigg stitch question
37:48—blocking method for socks
39:11—yarn dominance
41:49—ITAG pocket combining row at the cable
42:07—wrapping the brioche stitch on the shawl collar
44:16—wrapping stitches in 1 color brioche; working with a knit or a purl
45:55—tensioning yarn when working stranded with two hands
47:02—using a spinner device instead of towels when blocking
47:25—how to determine how large to make a project that will be felted
48:37—best ribbing to build up the back of the shawl collar
51:52—Suzanne’s favorite heel for basic socks
53:39—changing the rate of decreases at the toes to make a rounder toe
Join us in these knitting adventures.
*Pattern: Starry Starry Night Socks KAL by Suzanne Bryan - https://www.ravelry.com/patterns/library/starry-starry-night-socks
*Pattern: It Takes a Guild Cardigan KAL Tutorial by Suzanne Bryan
https://www.ravelry.com/patterns/library/it-takes-a-guild-cardigan-tutorial
Find the full list of videos for the It Takes a Guild Cardigan KAL in this playlist - https://www.youtube.com/playlist?list=PLLKJ9GuhEEwkRjQQ0-G-D-C2yuYxImcHF
Where to find me -
Knitting with Suzanne Bryan on Ravelry - https://www.ravelry.com/groups/knitting-with-suzanne-bryan
Knitting with Suzanne Bryan on FB- https://www.facebook.com/groups/1769286026429876/
KnittingSuzanne on Ravelry - https://www.ravelry.com/people/KnittingSuzanne
Suzannes Blog - http://www.knittingsuzanne.com Live with Suzanne 1/27/19](https://i.ytimg.com/vi/VlxuNp6aFj8/mqdefault.jpg)


