Uploaded September 2026 | Updated November 2026, 3 hours ago
25 years of selling watches means 25 years of hearing bracelet sizing horror stories. Stripped screws, lost collars, rubber straps cut too short. Here are my top 10 tips to size your watch bracelet right the first time.
The 10 Tips:
1) Clean area first — tray, mat, clean desk. You will lose something otherwise
2) Center the micro-adjust — before you do anything else, center it so you have adjustment room both ways after sizing
3) Check the back of the link — see an arrow? That's your push direction. No arrow? Might be a screw
4) Use the right tool — pin pusher for pins, screwdriver for screws. Wrong tool diameter wedges in the link and won't come out
5) Use the right size screwdriver — too small rounds out the slot, too large chews up the hole. Snug is enough — don't snap the screw head
6) Don't lose the pins and collars — collars blow off the table if you breathe on them. Cover them immediately
7) Rubber straps: measure twice, cut once — links can go back in, rubber can't go back on. Cut half of what you think you need, try it, then cut more
8) Center the clasp — remove links evenly from both sides. Never more than one link difference side to side
9) Check every screw when done — not just the ones you touched. Check them all, and check them periodically
10) Keep your extra links — bag them, store them in the watch box. You'll want them someday
Shop watch bracelets and tools at longislandwatch.com
25 years of selling watches means 25 years of hearing bracelet sizing horror stories. Stripped screws, lost collars, rubber straps cut too short. Here are my top 10 tips to size your watch bracelet right the first time.
The 10 Tips:
1) Clean area first — tray, mat, clean desk. You will lose something otherwise
2) Center the micro-adjust — before you do anything else, center it so you have adjustment room both ways after sizing
3) Check the back of the link — see an arrow? That's your push direction. No arrow? Might be a screw
4) Use the right tool — pin pusher for pins, screwdriver for screws. Wrong tool diameter wedges in the link and won't come out
5) Use the right size screwdriver — too small rounds out the slot, too large chews up the hole. Snug is enough — don't snap the screw head
6) Don't lose the pins and collars — collars blow off the table if you breathe on them. Cover them immediately
7) Rubber straps: measure twice, cut once — links can go back in, rubber can't go back on. Cut half of what you think you need, try it, then cut more
8) Center the clasp — remove links evenly from both sides. Never more than one link difference side to side
9) Check every screw when done — not just the ones you touched. Check them all, and check them periodically
10) Keep your extra links — bag them, store them in the watch box. You'll want them someday
Shop watch bracelets and tools at longislandwatch.com









