How to Replace the Friction Pack on the RS800 CVT Transmission @searspartsdirect
How to Replace the Friction Pack on the RS800 CVT Transmission  @searspartsdirect
Uploaded May 2023 | Updated November 2026, 4 days ago
This #diy #repair video shows how to replace the friction pack on a common RS800 CVT transaxle made by General Transmission. You'll need to replace the friction pack for loss or neutral or loss of drive in the riding mower.

Order the replacement friction pack from searspartsdirect.com

To have a Sears Technician replace the friction pack or repair your riding mower, schedule service online at searshomeservices.com/repair/riding-mower-repair-service

Transcript:
The next repair that we’re going to do is to replace the friction pack. This is on a fender-shifted unit with either a loss of neutral or loss of drive. To replace the friction pack, we must remove the driven kit and the drive kit – and we refer to other videos for those repairs (remove the driven kit -- youtu.be/i5ezGhkOdWw and remove the driver kit -- youtu.be/qhwhnjR_S-Y ). We’ve now removed the driven kit and the drive kit so now we’re going to remove the top cover, C-clips, shift arm and the friction pack. We remove all of the screws. We remove the C-clip, shift arm and the cover. There are 4 screws holding the friction pack. The best way to reach the one under the cam is to simply rotate this out of the way to get access. To get access to the bolt, we must remove the spring. You’ve got to rotate the cam. Then the friction pack comes off. The new friction pack is shipped with the pin. Training Bulletin TB71-59 will explain the removal of the pin (TB71-59 instructs you to set control lever in Neutral and connect the control arm to the transaxle – YOU MUST REMOVE THE SHIPPING PIN IMMEDIATELY AFTER ATTACHING THE CONTROL ARM – DON’T LEAVE THE SHIPPING PIN IN PLACE OR YOU WILL DAMAGE PARTS). At this time, we reinstall the friction pack. Tighten the screws. Reassembly starts with the cam holding the selector. It slides into place. Then reset the spring. The measurement between the spring must be 2.5 inches. The next step is the cover. Tightening torque should be 2.5 ft-lbs. Reattach the shift lever. Install the C-clip. Remove the pin. We have now reinstalled the drive kit and the driven kit.
How to Replace the Friction Pack on the RS800 CVT Transmission3 Easy Clothes Dryer HacksHow to adjust snowblower skid shoesHow to Connect Jumper Cables to a Riding MowerHow to Prevent BBQ Grill Flare-UpsHow to Fix a Flat Tire on a Riding MowerTop reasons why - Refrigerator won’t coolUse & Care Tips: 3 HVAC Maintenance StepsUse and Care Tips: Why You Need a Fridge Water FilterReplacing the Logic Board on a Garage Door OpenerTop reasons why - Electric dryer wont heatWasher Cycles Explained   Permanent Press, Delicate and Speed Wash #washer #laundry
Sears PartsDirect |

How to Replace the Friction Pack on the RS800 CVT Transmission

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER