Uploaded January 2023 | Updated November 2026, 3 hours ago
Visit us at:
searspartsdirect.com
Use Promo Code YOUTUBE to get 10% Off your parts order.
Or call 1-800-437-1673 to speak with a parts specialist.
This video from Sears PartsDirect shows how to replace a broken heating element in common electric dryers made by Kenmore, Whirlpool, Amana and Maytag.
If your electric dryer doesn't heat, check the heating coil on the element for damage. If it's damaged, replace the heating element.
Step 1: Shut off the power
Step 2: Remove the back panel
Step 3: Disconnect the wires
Step 4: Remove the heating element
Step 5: Transfer the high-limit thermostat to the new heating element
Step 6: Install the new heating element
Step 7: Reattach the back panel
Step 8: Plug in the dryer
The video includes this part:
Heating Element
searspartsdirect.com/product/5lzf5hr2wm-0026-110/id-279838
Transcript:
Before you begin, wear work gloves to protect your hands. Unplug the dryer. Remove the screws from the back panel. Remove the back panel from the dryer and set it aside. Disconnect the wires, using slot screwdriver to pry the wires off the spades if necessary. Remove the mounting screws from the heating element using a 1/4" nut driver and pull it off of the heater box. Remove the high-limit thermostat from the existing heating element and install it on the new heating element. Position the new heating element on the heater box and line up the mounting screw holes. Insert the mounting screws and tighten them firmly. Properly connect the wires to the new heating element. Warning: For safety and to avoid damage to the new element, the wires must be properly connected. Position the back panel on the back of the dryer. Line up the mounting screw holes. Insert the mounting screws and tighten them firmly. Plug the dryer into the wall outlet.
Visit us at:
searspartsdirect.com
Use Promo Code YOUTUBE to get 10% Off your parts order.
Or call 1-800-437-1673 to speak with a parts specialist.
This video from Sears PartsDirect shows how to replace a broken heating element in common electric dryers made by Kenmore, Whirlpool, Amana and Maytag.
If your electric dryer doesn't heat, check the heating coil on the element for damage. If it's damaged, replace the heating element.
Step 1: Shut off the power
Step 2: Remove the back panel
Step 3: Disconnect the wires
Step 4: Remove the heating element
Step 5: Transfer the high-limit thermostat to the new heating element
Step 6: Install the new heating element
Step 7: Reattach the back panel
Step 8: Plug in the dryer
The video includes this part:
Heating Element
searspartsdirect.com/product/5lzf5hr2wm-0026-110/id-279838
Transcript:
Before you begin, wear work gloves to protect your hands. Unplug the dryer. Remove the screws from the back panel. Remove the back panel from the dryer and set it aside. Disconnect the wires, using slot screwdriver to pry the wires off the spades if necessary. Remove the mounting screws from the heating element using a 1/4" nut driver and pull it off of the heater box. Remove the high-limit thermostat from the existing heating element and install it on the new heating element. Position the new heating element on the heater box and line up the mounting screw holes. Insert the mounting screws and tighten them firmly. Properly connect the wires to the new heating element. Warning: For safety and to avoid damage to the new element, the wires must be properly connected. Position the back panel on the back of the dryer. Line up the mounting screw holes. Insert the mounting screws and tighten them firmly. Plug the dryer into the wall outlet.










