Uploaded June 2022 | Updated November 2026, 2 days ago
This video shows how to remove the main control board (also called the CCU--central control unit), control panel and user interface control from a Maytag Epic Z front-load washer.
Unplug the washer before beginning washer disassembly.
To remove the top panel, remove the 3 screws along the back side of the panel.
Lift the top panel up slightly, while pulling it back. Then lift the top off the washer.
To remove the central control unit (main control board), slide a flat-bladed screw driver under the tabs securing the central control unit to the rear bracket. While pulling on the central control unit, lift the tabs to replace the control from the bracket.
Disconnect the wires from the central control unit.
To remove the control console, first remove the dispenser drawer.
Remove the screw securing the console to the washer cabinet.
Open the washer door and locate the slot underneath the console. Insert a flat-blade screwdriver to depress the locking tabs securing the console to the washer frame.
Lift up on the bottom of the console and pull it off. Guide the ribbon wire through the opening in the washer bracket.
To remove the user interface from the console, first remove the control knob.
Place the console face-down on a protected surface.
With a flat-blade screwdriver, press the tabs surrounding the user interface and pull the user interface from the console.
To order parts, visit our Sears PartsDirect website: searspartsdirect.com
This video shows how to remove the main control board (also called the CCU--central control unit), control panel and user interface control from a Maytag Epic Z front-load washer.
Unplug the washer before beginning washer disassembly.
To remove the top panel, remove the 3 screws along the back side of the panel.
Lift the top panel up slightly, while pulling it back. Then lift the top off the washer.
To remove the central control unit (main control board), slide a flat-bladed screw driver under the tabs securing the central control unit to the rear bracket. While pulling on the central control unit, lift the tabs to replace the control from the bracket.
Disconnect the wires from the central control unit.
To remove the control console, first remove the dispenser drawer.
Remove the screw securing the console to the washer cabinet.
Open the washer door and locate the slot underneath the console. Insert a flat-blade screwdriver to depress the locking tabs securing the console to the washer frame.
Lift up on the bottom of the console and pull it off. Guide the ribbon wire through the opening in the washer bracket.
To remove the user interface from the console, first remove the control knob.
Place the console face-down on a protected surface.
With a flat-blade screwdriver, press the tabs surrounding the user interface and pull the user interface from the console.
To order parts, visit our Sears PartsDirect website: searspartsdirect.com










