Uploaded May 2020 | Updated September 2026, 1 week ago
See this simple safe method of parting-off a long piece of large diameter bar on the Myford ML7 or any other small lathe. This is the only method where you can use a part-off tool a long distance from the jaw face. I have used the part-off set upside down, but you can also use this method with a tool set up the normal way.
See this simple safe method of parting-off a long piece of large diameter bar on the Myford ML7 or any other small lathe. This is the only method where you can use a part-off tool a long distance from the jaw face. I have used the part-off set upside down, but you can also use this method with a tool set up the normal way.
