How To Get Fine Finish Feeds On The Myford Lathes. Installing A Tumbler Gear @SteveJordan
How To Get Fine Finish Feeds On The Myford Lathes. Installing A Tumbler Gear @SteveJordan
Uploaded April 2023 | Updated September 2026, 1 week ago
If you have just bought a Myford ML7 or another Myford lathe, you might be wondering how to get the fine feeds that are required to get good finishes. In this short video I show what gear you need and how easy it is to install it. This reduces the feed by 50% from the standard gear, that's often installed on second hand Myford lathes.
How To Get Fine Finish Feeds On The Myford Lathes. Installing A Tumbler GearBlue Nano Carbide Insert Test Intermittent Cutting On The Mini LatheMy New Myford ML7 Countershaft Pressure Button Oiler ToolTHE VEVOR 12 TON HYDRAULIC PRESS. ASSEMBLY, REVIEW & TEST. Plus using it to make a coin pendantMachining A Chuck Jaw-Held Backplate For The 80mm Sanou ChuckEasy To Make Simple Ball Turning Mandrel Plus Some New toolsMy Toolpost Fixture Alignment Locking Screw Upgrade.The TM-2 Polishing Buffing Machine Plus The Best Abrasive CompoundAN Easy Low Cost Method Of Blackening Steel. Rust Protection.My Brothers Fully Restored Aerograph Devilbiss Air Compressor. #aircompressor #restorationAn Indexing Setup on the Myford ML7 using a right angled drilling tool.EASY TO MAKE DOUBLE ENDED TOOLPOST DTI FIXTURE TOOL
Steve Jordan |

How To Get Fine Finish Feeds On The Myford Lathes. Installing A Tumbler Gear

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER