Uploaded February 2017 | Updated September 2026, 2 weeks ago
Description: This is just a simple Arbor I made for my Harbor Freight Sanding Disk. The disk is designed to fit on a hand grinder but I wanted to use my hand drill. So I went to Lowes and found a bolt that would screw into the sanding disk. Then I turned the bolt down on my lathe to 3/8's inch so that i could use it in my 3/8" Chuck hand drill. After I screwed it and locked it down with a nut on the back side in I cut the end off so that it wouldn't stick out and ruin the area I was sanding.
Parts Used: 5/8's x 11 pitch Bolt about 3" long.
Tools Used: Harbor Freight 3 in 1 Multi Purpose Machine.
Hope you all enjoyed the simple project.
Thanks for watching. Best Wishes n Blessings. Keith
Description: This is just a simple Arbor I made for my Harbor Freight Sanding Disk. The disk is designed to fit on a hand grinder but I wanted to use my hand drill. So I went to Lowes and found a bolt that would screw into the sanding disk. Then I turned the bolt down on my lathe to 3/8's inch so that i could use it in my 3/8" Chuck hand drill. After I screwed it and locked it down with a nut on the back side in I cut the end off so that it wouldn't stick out and ruin the area I was sanding.
Parts Used: 5/8's x 11 pitch Bolt about 3" long.
Tools Used: Harbor Freight 3 in 1 Multi Purpose Machine.
Hope you all enjoyed the simple project.
Thanks for watching. Best Wishes n Blessings. Keith
