Uploaded September 2026 | Updated November 2026, 1 day ago
How to factory reset an Orbi satellite wifi router
Leave the Orbi satellite powered on.
Find the small Reset button on the back/bottom of the satellite.
Use a paper clip or SIM-eject tool to press the Reset button.
Hold it down until the satellite's LED indicates that it has reset. On many Orbi models, this is about 7 seconds; NETGEAR's current general instructions say to hold Reset until the power LED begins blinking/pulsing amber.
Release the button.
Give the satellite several minutes to reboot the wi fi router
Important: The factory reset erases the satellite's stored configuration and its previous connection to the Orbi network. It does not factory-reset your main Orbi router unless you reset the router separately.
After the reset
You'll normally need to sync the satellite back to your Orbi router. Put the satellite relatively close to the main Orbi router initially, then use the Sync buttons on the router and satellite, or add the satellite through the Orbi app, depending on your model.
For example, NETGEAR's instructions for the older RBS10 specifically say to reset the satellite, wait for it to reboot, press Sync on the router, and then press Sync on the satellite within two minutes.#netgear
Disclaimer: As an Amazon Associate I earn from qualified purchases.
How to factory reset an Orbi satellite wifi router
Leave the Orbi satellite powered on.
Find the small Reset button on the back/bottom of the satellite.
Use a paper clip or SIM-eject tool to press the Reset button.
Hold it down until the satellite's LED indicates that it has reset. On many Orbi models, this is about 7 seconds; NETGEAR's current general instructions say to hold Reset until the power LED begins blinking/pulsing amber.
Release the button.
Give the satellite several minutes to reboot the wi fi router
Important: The factory reset erases the satellite's stored configuration and its previous connection to the Orbi network. It does not factory-reset your main Orbi router unless you reset the router separately.
After the reset
You'll normally need to sync the satellite back to your Orbi router. Put the satellite relatively close to the main Orbi router initially, then use the Sync buttons on the router and satellite, or add the satellite through the Orbi app, depending on your model.
For example, NETGEAR's instructions for the older RBS10 specifically say to reset the satellite, wait for it to reboot, press Sync on the router, and then press Sync on the satellite within two minutes.#netgear
Disclaimer: As an Amazon Associate I earn from qualified purchases.







