Uploaded October 2023 | Updated September 2026, 2 days ago
Today's video is continuing on with the fish room build.
A fish room central air line is very important if you want to have lots of tanks.
Things you will need:
19mm poly irrigation line roll
Pope 4mm microjet, thread to barb adapters
Drill and 7/64 imperial drill bit
19mm poly irrigation elbows, stop-ends, and t-sections
19mm clips - not 100% necessary I found
Air pump of choice
Also a tip, I found that a little socket, that goes over the micro jet adapters hex, helped to push, and thread them in. This saved my hands from getting worn out. However I do believe there are special tools you can buy for specifically putting in the micro jet adapters, but I didn’t have this tool, hence the method used.
Thanks to people who commented I now have the solution to the kinking problem as well, use a heat gun to soften and straighten the piping. 👇 Go check out the comments below for the info on that.
If you have any questions feel free to leave a comment below 👇
Today's video is continuing on with the fish room build.
A fish room central air line is very important if you want to have lots of tanks.
Things you will need:
19mm poly irrigation line roll
Pope 4mm microjet, thread to barb adapters
Drill and 7/64 imperial drill bit
19mm poly irrigation elbows, stop-ends, and t-sections
19mm clips - not 100% necessary I found
Air pump of choice
Also a tip, I found that a little socket, that goes over the micro jet adapters hex, helped to push, and thread them in. This saved my hands from getting worn out. However I do believe there are special tools you can buy for specifically putting in the micro jet adapters, but I didn’t have this tool, hence the method used.
Thanks to people who commented I now have the solution to the kinking problem as well, use a heat gun to soften and straighten the piping. 👇 Go check out the comments below for the info on that.
If you have any questions feel free to leave a comment below 👇
