Uploaded May 2018 | Updated November 2026, 1 hour ago
A homemade soldering station, made from a schematic I found online (NOT my design, though I modified it just a tinge).
Circuit Exchange International (CXI), design by Abu-Hafss:
zen22142.zen.co.uk/Circuits/Testgear/energy_saver_ss.htm
This particular station will save power and preserve tip life. While the iron is resting on its stand, it heats up a thermistor and the iron is put into a pulsed state, with 20% duty cycle pulsing. Once the iron is picked up to solder, the thermistor cools some and the circuit gives constant power to the iron.
Amongst the slight tweaks I did to the circuit, I forgot to mention that I also made the relay go to the +12V power rail instead of pin 3 of the 555. It still operates the same, but does not take current draw from the 555 to run the relay coil.
A homemade soldering station, made from a schematic I found online (NOT my design, though I modified it just a tinge).
Circuit Exchange International (CXI), design by Abu-Hafss:
zen22142.zen.co.uk/Circuits/Testgear/energy_saver_ss.htm
This particular station will save power and preserve tip life. While the iron is resting on its stand, it heats up a thermistor and the iron is put into a pulsed state, with 20% duty cycle pulsing. Once the iron is picked up to solder, the thermistor cools some and the circuit gives constant power to the iron.
Amongst the slight tweaks I did to the circuit, I forgot to mention that I also made the relay go to the +12V power rail instead of pin 3 of the 555. It still operates the same, but does not take current draw from the 555 to run the relay coil.










