Gemfan 5x5x3 props on Vortex 250 Lumineer Edition - Ground recording @techdaemn
Gemfan 5x5x3 props on Vortex 250 Lumineer Edition - Ground recording  @techdaemn
Uploaded February 2016 | Updated September 2026, 19 hours ago
Bunch of firemen dropped by at the end of a MultiGP event, and wanted to see what a 70mph quad looked like, so I set up a couple sets of passenger goggles and took em for a ride. Flight was
a little bumpy because the wind was blowing about 15-20mph. Most of the speed runs were crosswise to the wind.

These Gemfan 5x5x3 props have a thick hub, with a really smooth transition into the blades. They're very quiet (about half the volume of the Vortex's stock Gemfan 5045's), very fast and grip hard in the turns. However, if you push em, they burn a lot of current. A mile above sea level in 15% thinner air, I'm pull over 65 Amps at full throttle. At sea level, that's going to be around 80.
Gemfan 5x5x3 props on Vortex 250 Lumineer Edition - Ground recordingDaemon Relay - Explained#DJI O4 Air Unit Pro raw onboard video 2.7K@60fps Ultra Wide/Rock Steady on #iflight #CineLR #fpvFPV - Funjet - Mobius Actioncam - Moongel anti-vibe mount testBeta95X with Caddx Vista first flight at the school yardByte Frost in the forest (comparison to DJI FPV)200mW 1.3Ghz  vs.  350mW 5.8Ghz over rocky ridgeHero 6 Black - fmware v2.01 - Stablization on - medium low lightInav Profile 2 - Max iterm windup in 25-45mph windy mountains - Dragon V2Two Ninja Stars and two unintentional flicks with D80 at Jones PassFPV - Wandering through forest - Ground RecordingNano Goblin -  Predator Micro V2 + Rapidfire - long raw flight
techdaemon |

Gemfan 5x5x3 props on Vortex 250 Lumineer Edition - Ground recording

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER