Gas spring 4, some tape and glue, finally @metalmusings
Gas spring 4, some tape and glue, finally @metalmusings
Uploaded March 2020 | Updated September 2026, 1 day ago
Finally the gas spring project is coming to an end. In this episode I try milling out the contours of the upper bracket using painters tape and super glue to hold the work piece.
Gas spring 4, some tape and glue, finallyScrews for the gas torch roller guideTurning with the new spindle motorChain saw chop sawWorking on the wheel axle (lots of turning)New lathe spindle. Part 11. Two more discsAll new electronicsLubricating the ball screwMake my own EtherCAT device 6. Stepper motor driverTramming deviceSilly work piece holding milling a gas torch roller guideSawmill build - 4. It costed two end mills and a paint brush
MetalMusings |

Gas spring 4, some tape and glue, finally

SHARE TO X SHARE TO REDDIT SHARE TO FACEBOOK WALLPAPER