Uploaded June 2021 | Updated November 2026, 1 hour ago
How can we create a spout on a beaker using surfacing? The spout not only needs to protrude out but taper down as well. We also have the challenge of blending the spout smoothly with the adjacent faces.
Link to post:
forums.autodesk.com/t5/fusion-360-design-validate/making-a-small-water-spout-extrusion/td-p/10350636
If you have found this video useful and would like to support me, you can buy me a coffee at
buymeacoffee.com/fusion360school
or you can also support me on Patreon at
patreon.com/fusion360school?fan_landing=true
Any contribution can go towards improving the quality of the channel. Thank you.
#fusion360school
#fusion360BeakerSpout
0:00 Intro
0:26 Cylinder
0:45 Surface trim
2:28 Spout outline from the top
4:44 Tapering of spout
6:26 Spline to control spout bottom
7:20 Loft
8:35 Stitch and thicken
How can we create a spout on a beaker using surfacing? The spout not only needs to protrude out but taper down as well. We also have the challenge of blending the spout smoothly with the adjacent faces.
Link to post:
forums.autodesk.com/t5/fusion-360-design-validate/making-a-small-water-spout-extrusion/td-p/10350636
If you have found this video useful and would like to support me, you can buy me a coffee at
buymeacoffee.com/fusion360school
or you can also support me on Patreon at
patreon.com/fusion360school?fan_landing=true
Any contribution can go towards improving the quality of the channel. Thank you.
#fusion360school
#fusion360BeakerSpout
0:00 Intro
0:26 Cylinder
0:45 Surface trim
2:28 Spout outline from the top
4:44 Tapering of spout
6:26 Spline to control spout bottom
7:20 Loft
8:35 Stitch and thicken










